Exam JN0-352 Topic 1 Question 33 Discussion

Actual exam question for Juniper's JN0-352 exam
Question #: 33
Topic #: 1
Referring to the exhibit, which two configuration changes must you apply for packets to reach from R1 to R3 using IS-IS? (Choose two.)

Suggested Answer: A,D Vote an answer

A) On R1, enable Level 1 on the ge-0/0/1 interface. In IS-IS, both levels (Level 1 and Level 2) are enabled by default when you enable IS-IS on an interface1. Level 1 systems route within an area.
If the destination is outside an area, Level 1 systems route toward a Level 2 system. Therefore, enabling Level 1 on the ge-0/0/1 interface on R1 would allow packets to reach from R1 to R3.
D) On R3 enable Level 1 on the ge-0/0/4 interface Similarly, enabling Level 1 on the ge-0/0/4 interface on R3 would allow packets to reach from R1 to R3. These explanations are based on the IS-IS configuration documents and learning resources available at Juniper Networks1 and Cisco.

by Heather at Jul 17, 2026, 10:12 AM

Limited Time Offer

15%

Off

Get Premium JN0-352 Questions as Interactive Self Test Engine or PDF

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
0
0
0
10