Free 200-601 Questions for Cisco Managing Industrial Networks for Manufacturing with Cisco Technologies 200-601 Exam as PDF & Practice Test Engine
Refer to the exhibit.
Which three options are needed to configure NAT on router GW so PC1 and PC2 will be able to ping 203.0.113.1? (Choose three)
Which three options are needed to configure NAT on router GW so PC1 and PC2 will be able to ping 203.0.113.1? (Choose three)
Correct Answer: D,E,F
Vote an answer
Profinet has been disabled on a Cisco Industrial Ethernet switch, which CLI commands correctly enable ProfiNET on VLAN 10?
Correct Answer: D
Vote an answer
How are I/O timeout and Safety I/O timeout calculated?
Correct Answer: A
Vote an answer
Refer to the exhibit. The Robot Cell is in a bottling plant. This cell environment needs to consider high flex, EMI, and possible exposure to moisture. Which physical media components need to be considered to prevent network degradation or interruptions?
Correct Answer: A
Vote an answer
If the Link Fault alarm is connected to the minor relay and the FCS Bit Error Rate alarm is connected to the major relay, which commands will create an alarm profile called GigE with the alarms correctly mapped to the minor and major relays?
Correct Answer: A
Vote an answer
After commissioning several Stratix 5700 switches in a ring topology, you want to verify the installation against the network logical design. Specifically, you want to verify where the
IGMP querier resides. What command can be issued in CLI to display the IP of the querier per VLAN?
IGMP querier resides. What command can be issued in CLI to display the IP of the querier per VLAN?
Correct Answer: C
Vote an answer
Which five are characteristics that describe Cisco Industrial switches? (Choose five)
Correct Answer: A,B,C,E,F
Vote an answer
Which option best describes the ProfiNET Discovery and Configuration Protocol (DCP)?
Correct Answer: A
Vote an answer
0
0
0
10