Free 200-120 Questions for Cisco CCNA Cisco Certified Network Associate CCNA (803) 200-120 Exam as PDF & Practice Test Engine

Exam Code/Number: 200-120
Exam Name/Title: CCNA Cisco Certified Network Associate CCNA (803)
Certification Provider: Cisco
Corresponding Certification: CCNA

Exam Questions: 364
Updated On: Jul 20, 2026

Question #1

An administrator is trying to ping and telnet from SwitchC to RouterC with the results shown below.

Click the console connected to RouterC and issue the appropriate commands to answer the questions.

What would be the effect of issuing the command ip access-group 115 in on the s0/0/1 interface?

A. No host could connect to RouterC through s0/0/1.

B. FTP, FTP-DATA, echo, and www would work but telnet would fail.

C. Only traffic from the 10.4.4.0 network would pass through the interface.

D. Telnet and ping would work but routing updates would fail.

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for ExamDiscuss members. You can sign-up / login (it's free).

Question #2

Refer to Exhibit:

How many broadcast domains are shown in the graphic assuming only the default VLAN is configured on the switches?

A. two

B. twelve

C. one

D. six

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for ExamDiscuss members. You can sign-up / login (it's free).

Question #3

Refer to the exhibit.

Which subnet mask will place all hosts on Network B in the same subnet with the least amount of
wasted addresses?

A. 255.255.248.0

B. 255.255.255.0

C. 255.255.254.0

D. 255.255.252.0

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for ExamDiscuss members. You can sign-up / login (it's free).

Question #4

Which three statements about link-state routing are true? (Choose three.)

A. Updates are sent to a multicast address by default.

B. It uses split horizon.

C. RIP is a link-state protocol.

D. Routes are updated when a change in topology occurs.

E. OSPF is a link-state protocol.

F. Updates are sent to a broadcast address.

Discussion 0

Correct Answer: A,D,E Vote an answer

Question #5

The output of the show frame-relay pvc command shows "PVC STATUS = INACTIVE". What does this mean?

A. The PVC is not configured on the local switch.

B. The PVC is configured correctly, is operating normally, and is no longer actively seeking the address of the remote router.

C. The PVC is configured correctly on the local switch, but there is a problem on the remote end of the PVC.

D. The PVC is configured correctly, is operating normally, and is waiting for interesting traffic to trigger a call to the remote router.

E. The PVC is configured correctly and is operating normally, but no data packets have been detected for more than five minutes.

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for ExamDiscuss members. You can sign-up / login (it's free).

Question #6

Which two commands can be used to verify a trunk link configuration status on a given Cisco switch interface? (Choose two.)

A. show interface switchport

B. show interface trunk

C. show interface interface

D. show interface vlan

E. show ip interface brief

Discussion 0

Correct Answer: A,B Vote an answer

Explanation: Only visible for ExamDiscuss members. You can sign-up / login (it's free).

Question #7

What are two reasons that duplex mismatches can be difficult to diagnose? (Choose two.)

A. The interface displays a connected (up/up) state even when the duplex settings are mismatched.

B. The symptoms of a duplex mismatch may be intermittent.

C. Autonegotiation is disabled.

D. Full-duplex interfaces use CSMA/CD logic, so mismatches may be disguised by collisions.

E. 1-Gbps interfaces are full-duplex by default.

Discussion 0

Correct Answer: A,B Vote an answer

Question #8

Which two options are valid WAN connectivity methods? (Choose two.)

A. Ethernet

B. L2TPv3

C. PPP

D. DSL

E. WAP

Discussion 0

Correct Answer: C,D Vote an answer

Explanation: Only visible for ExamDiscuss members. You can sign-up / login (it's free).

Question #9

Which statements describe the routing protocol OSPF? (Choose three.)

A. It allows extensive control of routing updates.

B. It supports VLSM.

C. It confines network instability to one area of the network.

D. It increases routing overhead on the network.

E. It is used to route between autonomous systems.

F. It is simpler to configure than RIP v2.

Discussion 0

Correct Answer: A,B,C Vote an answer

Explanation: Only visible for ExamDiscuss members. You can sign-up / login (it's free).

Question #10

DRAG DROP
Refer to the exhibit. PC_1 is sending packets to the FTP server. Consider the packets as they leave RouterA interface Fa0/0 towards RouterB. Drag the correct frame and packet address to their place in the table.

Discussion 0

Correct Answer:

Explanation:

Question #11

Which IPv6 header field is equivalent to the TTL?

A. Hop Count

B. TTD

C. Flow Label

D. Hop Limit

E. Scan Timer

Discussion 0

Correct Answer: D Vote an answer

Question #12

Which three of these statements regarding 802.1Q trunking are correct? (Choose three.)

A. 802.1Q native VLAN frames are untagged by default.

B. 802.1Q trunks should have native VLANs that are the same at both ends.

C. 802.1Q trunks can use 10 Mb/s Ethernet interfaces.

D. 802.1Q trunks require full-duplex, point-to-point connectivity.

E. 802.1Q trunking ports can also be secure ports.

Discussion 0

Correct Answer: A,B,C Vote an answer

Explanation: Only visible for ExamDiscuss members. You can sign-up / login (it's free).

Free 200-120 Questions for Cisco CCNA Cisco Certified Network Associate CCNA (803) 200-120 Exam as PDF & Practice Test Engine

Download Free Cisco 200-120 Demo