Exam 5V0-35.21 Topic 5 Question 112 Discussion

Actual exam question for VMware's 5V0-35.21 exam
Question #: 112
Topic #: 5
Which three steps are required to enable east/west firewall in VMware Cloud Director Tenant Portal? (Choose three.)

Suggested Answer: B,C,E Vote an answer

To enable east/west firewall in VMware Cloud Director Tenant Portal, you need to perform the following steps:
Login to Customer Organization and go to Networking Section of Tenant Portal. This is where you can access the networking capabilities provided by NSX Data Center for vSphere in your VMware Cloud Director organization virtual data center.
Go to Edge Gateways and enable firewall on one of the Edge Gateways. This will allow you to configure the edge gateway firewall rules for north/south traffic enforcement and perimeter security functionality. You can also enable other services such as NAT, VPN, load balancing, etc. on the edge gateway.
Go to Networking and enable Distributed Firewall for one of the Network inside the Network section.
This will allow you to configure the distributed firewall rules for east/west traffic isolation and access control. You can also apply security policies and groups to the network and the virtual machines within it.
References: NSX Data Center for vSphere Firewall Configuration in the VMware Cloud Director Tenant Portal; Getting Started with the VMware Cloud Director Tenant Portal

by Lyle at Oct 25, 2024, 12:24 AM

Limited Time Offer

15%

Off

Get Premium 5V0-35.21 Questions as Interactive Self Test Engine or PDF

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
0
0
0
10