Free NCP-MCI Questions for Nutanix Certified Professional-Multicloud Infrastructure (NCP-MCI) v7.5 NCP-MCI Exam as PDF & Practice Test Engine

Which service is part of Prism Central backup?

During an LCM upgrade, the `pre-check test_ahv_entering_mm_pinned_vms` pre-check fails on an AHV host. The administrator reviews the listed VMs and finds that:
* One VM is configured as an Agent VM
* Two VMs are running Windows Defender Credential Guard
* One VM has a vGPU-enabled
Based on the behavior of this pre-check, which action is required to allow the host to enter maintenance mode and proceed with the LCM upgrade?

An administrator is planning a new AHV cluster deployment with multiple nodes and wants to include a cluster virtual IP for external access.
How many IPv4 addresses should be reserved?

Refer to the exhibit. An administrator has been tasked with enabling LACP on an AHV cluster. In the exhibit, which option is the best to select for Bond Type when completing the task?

While configuring a remote site for PD-Based DR, an administrator elects to skip vStore mapping.
Assuming the same container names don't exist on the two sites, what is the expected behavior of data placement at the remote site for replications?

An administrator needs to expand an existing cluster with a new node that has no operating system. Only hai IP addresses are available. Out of band management (IPMI) has not been configured. Which tool should be used to image the node?

A company needs to comply with a new company policy requiring the use of an external, cloud based, recovery point location. To accomplish this task, an administrator needs to strengthen the Disaster Recovery configurations.
What is the most cost-efficient option?

What is the default compression setting when a new storage container is created in Prism Central?

An administrator is troubleshooting intermittent network connectivity issues on an AHV host and runs the following command:
`ethtool -S eth0 | grep error`
Output:
`rx_crc_errors: 4389675534`
`rx_missed_errors: 0`
`tx_aborted_errors: 0`
`tx_carrier_errors: 0`
`tx_window_errors: 0`
`rx_long_length_errors: 0`
`rx_short_length_errors: 0`
`rx_align_errors: 0`
`rx_errors: 0`
`tx_errors: 0`
`rx_length_errors: 0`
`rx_over_errors: 0`
`rx_frame_errors: 0`
`rx_fifo_errors: 0`
`tx_fifo_errors: 0`
`tx_heartbeat_errors: 0`
The command is executed multiple times and it is observed that the CRC errors are incrementing.
What is the most likely cause of the high `rx_crc_errors` observed on the interface?

An administrator wants to run a workload at site A, but replicate it to two clusters with different RPOs. Which replication option fits the needs?