Exam 201-450 Topic 6 Question 51 Discussion

Actual exam question for Lpi's 201-450 exam
Question #: 51
Topic #: 6
Which of the following commands should be used in a bash script that needs a variable containing the IP address of the eth0 interface?
The output for the command ifconfig eth0 is shown below:
eth0 Link encap:Ethernet HWaddr 00:0C:29:CB:FA:30
inet addr:192.168.246.11 Bcast:192.168.246.255 Mask:255.255.255.0 UP
BROADCAST
RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4721 errors:0 dropped:0 overruns:0 frame:0 TX packets:3216
errors:0
dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000
RX bytes:445184 (434.7 Kb) TX bytes:512968 (500.9 Kb) Interrupt:185
Base address:0x1080

Suggested Answer: D Vote an answer

by Solomon at Jul 09, 2025, 01:04 AM

Limited Time Offer

15%

Off

Get Premium 201-450 Questions as Interactive Self Test Engine or PDF

Comments

Chosen Answer:
This is a voting comment (?) , you can switch to a simple comment.
Switch to a voting comment New
Nick name: Submit Cancel
A voting comment increases the vote count for the chosen answer by one.

Upvoting a comment with a selected answer will also increase the vote count towards that answer by one. So if you see a comment that you already agree with, you can upvote it instead of posting a new comment.
0
0
0
10