Free FCSS_EFW_AD-7.4 Questions for Fortinet FCSS - Enterprise Firewall 7.4 Administrator FCSS_EFW_AD-7.4 Exam as PDF & Practice Test Engine

Refer to the exhibit, which shows a physical topology and a traffic log.

The administrator is checking on FortiAnalyzer traffic from the device with IP address 10.1.10.1, located behind the FortiGate ISFW device.
The firewall policy in on the ISFW device does not have UTM enabled and the administrator is surprised to see a log with the action Malware, as shown in the exhibit.
What are the two reasons FortiAnalyzer would display this log? (Choose two.)

Refer to the exhibit, which shows the VDOM section of a FortiGate device.

An administrator discovers that webfilter stopped working in Core1 and Core2 after a maintenance window.
Which two reasons could explain why webfilter stopped working? (Choose two.)

Refer to the exhibit, which shows an OSPF network.

Which configuration must the administrator apply to optimize the OSPF database?

During the maintenance window, an administrator must sniff all the traffic going through a specific firewall policy, which is handled by NP6 interfaces. The output of the sniffer trace provides just a few packets.
Why is the output of sniffer trace limited?

Refer to the exhibits.
Network topology

Output from the command config system ha

A network diagram and the output from the command config system ha are shown.
The administrator has configured the cluster with the commands shown in the exhibit.
Why is the HA cluster not forming?

A company's users on an IPsec VPN between FortiGate A and B have experienced intermittent issues since implementing VXLAN. The administrator suspects that packets exceeding the 1500- byte default MTU are causing the problems.
In which situation would adjusting the interface's maximum MTU value help resolve issues caused by protocols that add extra headers to IP packets?

You want to know which content processor (CP) model FortiGate contains.
Which command should you enter?

Refer to the exhibit, which shows a network diagram showing the addition of site 2 with an overlapping network segment to the existing VPN IPsec connection between the hub and site 1.

Which IPsec phase 2 configuration must an administrator make on the FortiGate hub to enable equal-cost multi-path (ECMP) routing when multiple remote sites connect with overlapping subnets?