Free D-PCM-DY-23 Questions for EMC Dell PowerSwitch Campus Deploy 2023 D-PCM-DY-23 Exam as PDF & Practice Test Engine
Standard IP access-lists are not supported on Dell PowerSwitch N-Series switches.
Which of these extended IP access-lists could be used to emulate the function of a Standard IP access- list?
Which of these extended IP access-lists could be used to emulate the function of a Standard IP access- list?
Correct Answer: A
Vote an answer
If Client B sends a packet to Client A, what is the highest level of the network hierarchy that the packet will transverse?
Correct Answer: D
Vote an answer
What is an accurate statement about configuring a LAG on a Dell EMC N-Series switch?
Correct Answer: C
Vote an answer
What are key features of the Dell EMC N4064 or N4064F switches?
Correct Answer: B
Vote an answer
A user connects via serial to a switch in a stack and gets the following message: "CLI-Unavailable" What is the likely reason for this message?
Correct Answer: B
Vote an answer
What is a recommended configuration for an MLAG peer-link on a Dell EMC N-Series switch?
Correct Answer: B
Vote an answer
A network administrator is setting up a Dell EMC N-Series PoE switch. The administrator is looking for a protocol that can deliver information to the end device that allows for refinement and fine tuning.
Which protocol option should be used?
Which protocol option should be used?
Correct Answer: A
Vote an answer
When DSCP is used for QoS prioritization, which type of service is typically used for voice traffic?
Correct Answer: B
Vote an answer
Refer to the Exhibit.
A network administrator needs to configure the switches to allow traffic to communicate from Host 1 to Host 2.
Which recommended switch port mode should the interconnecting switch ports be configured?
A network administrator needs to configure the switches to allow traffic to communicate from Host 1 to Host 2.
Which recommended switch port mode should the interconnecting switch ports be configured?
Correct Answer: A
Vote an answer
What is the PoE source maximum power budget for a Class 3 end device?
Correct Answer: A
Vote an answer
A switch has the following IP configuration:
- VLAN10: IP address 192.168.10.1/24
- VLAN20: IP address 192.168.20.1/24
- VLAN30: IP address 192.168.30.1/24
and the following routes:
0.0.0.0/0 192.168.10.10
10.0.0.0/8 192.168.20.10
A packet with source 192.168.30.10 and destination 10.10.10.10 matches a policy-based routing clause using the set default next-hop 192.168.10.2 parameter.
What is next hop that will be used by the switch to forward the packet?
- VLAN10: IP address 192.168.10.1/24
- VLAN20: IP address 192.168.20.1/24
- VLAN30: IP address 192.168.30.1/24
and the following routes:
0.0.0.0/0 192.168.10.10
10.0.0.0/8 192.168.20.10
A packet with source 192.168.30.10 and destination 10.10.10.10 matches a policy-based routing clause using the set default next-hop 192.168.10.2 parameter.
What is next hop that will be used by the switch to forward the packet?
Correct Answer: A
Vote an answer
When configuring a standard MAC ACL on a Dell EMC N-Series switch, how is the ACL filtered?
Correct Answer: A
Vote an answer
Which switch port mode is recommended for ports on a Dell EMC N-Series switch with IP phones using voice VLAN?
Correct Answer: C
Vote an answer
0
0
0
10