Free DC0-200 Questions for Dell Certified Server Professional DC0-200 Exam as PDF & Practice Test Engine

Exam Code/Number: DC0-200
Exam Name/Title: Certified Server Professional Exam
Certification Provider: Dell
Corresponding Certification: Dell Certification

Exam Questions: 120
Updated On: Oct 06, 2026

Question #1

What is the benefit of ECC memory?

A. provides redundancy by maintaining parity info on the DRAM to detect and correct single bit errors

B. provides speed improvements by accessing memory in parallel

C. provides speed improvements by allowing addressing to be set for the next access to the same DIMM, while data are being read from the previous access

D. provides redundancy by allowing defective memory to be disabled

Discussion 0

Correct Answer: A Vote an answer

Question #2

Which three requirements must you meet to install OMSA in a Red Hat Linux environment? (Choose three.)

A. The running kernel must have loadable module support enabled.

B. You must do a custom installation to support Linux.

C. The "ucd-snmp" or "net-snmp" package that is provided with the operating system must be installed.

D. You must purchase the Linux version of OMSA.

E. You must be logged in as root.

Discussion 0

Correct Answer: A,C,E Vote an answer

Question #3

Which statement is true about using the Save feature of BASP?

A. It is only available in Windows 2000.

B. It lets you transfer teaming configurations to other servers.

C. It is used to install and configure the Broadcom Ethernet Controller driver.

D. It saves a configuration as an executable file.

Discussion 0

Correct Answer: B Vote an answer

Question #4

A PowerEdge server contains 8 GB of memory. During the POST sequence, only 256 MB is shown. What is the most likely problem?

A. OS Install Mode is enabled in the System Setup.

B. There is a PERC card installed.

C. The memory card needs to be reseated.

D. The memory card is in Safe Mode.

E. The processor stepping is mismatched.

Discussion 0

Correct Answer: A Vote an answer

Question #5

Using Array Manager, which statement is true about reassigning the drive letter of your active volume (containing your boot disk)?

A. You "Remove" the drive letter first, then "Add" a new drive letter.

B. You can only change drive letters on volumes in extended partitions.

C. You cannot reassign the drive letter of your active volume.

D. You mount a volume to your boot disk BEFORE reassigning a drive letter.

Discussion 0

Correct Answer: C Vote an answer

Question #6

What is the correct NIC teaming for the Intel Proprietary Method to accomplish load balancing?

A. SLB

B. ALB

C. ATF

D. AFT

Discussion 0

Correct Answer: B Vote an answer

Question #7

What happens when you specify a Preferred Primary Adapter in Windows 2000 for an AFT NIC team?

A. You specify the desired card for all outgoing traffic for the team. The other members will still accept incoming packets.

B. You specify which adaptor will take the load until it is saturated, then the other members will start accepting packets until the Preferred Primary is just below the saturation point.

C. You specify which adaptor will take the entire load. The other NICs will be used only when the Preferred Primary fails.

D. You specify the desired card for all incoming traffic for the team. The other members will still transmit outgoing packets.

Discussion 0

Correct Answer: C Vote an answer

Question #8

If there is a loss of power redundancy on your PowerEdge server, in which three ways can Dell OpenManage IT Assistant report this? (Choose three.)

A. Dell IT Assistant sends an alert to Dell OpenManage Server Administrator.

B. The status panel for that system indicates which power supply failed.

C. Systems Status is marked as "Warning" in OpenManage IT Assistant.

D. An SNMP trap can be logged in the OpenManage IT Assistant.

Discussion 0

Correct Answer: B,C,D Vote an answer

Free DC0-200 Questions for Dell Certified Server Professional DC0-200 Exam as PDF & Practice Test Engine

Download Free Dell DC0-200 Demo