Free 642-732 Questions for Cisco Conducting Cisco Unified Wireless Site Survey (CUWSS) v2.0 642-732 Exam as PDF & Practice Test Engine

Exam Code/Number: 642-732
Exam Name/Title: Conducting Cisco Unified Wireless Site Survey (CUWSS) v2.0
Certification Provider: Cisco
Corresponding Certification: CCNP Wireless

Exam Questions: 195
Updated On: Jun 15, 2026

Question #1

Which two details are specified in the Executive Summary section of the Site Survey Report? (Choose two.)

A. customer and site surveyor contact details

B. proposed location for each AP

C. coverage map

D. total number of APs

E. expressed requirements set by customer

Discussion 0

Correct Answer: D,E Vote an answer

Question #2

The customer has an existing 802.11b/g network with Cisco 2500 controllers. The customer would like to migrate to an 802.11a/b/g/n WLAN. Which network infrastructure issue might impact client performance in this proposed controller-based solution?

A. The additional application load placed on servers by 802.11n clients.

B. The additional load placed on a RADIUS server by 802.1X authentication traffic on the first work day of each week.

C. The added delay WDS imposes on the client when they roam from one AP to another.

D. A bottleneck may occur if the access switch port to the AP only supports 100 Mb/s full duplex.

Discussion 0

Correct Answer: D Vote an answer

Question #3

Which infrastructure issue needs to be verified and potentially resolved before deploying a centralized 802.11n WLAN?

A. That all the access layer switches that the 802.11n APs will connect to support 802.3af power.

B. That all the access layer switches that the 802.11n APs will connect to contain 10/100/1000 Ethernet ports.

C. The proposed location for the WCS.

D. The location of application and authentication servers.

E. The proposed location for the WDS server.

Discussion 0

Correct Answer: B Vote an answer

Question #4

Which wireless tool would be most useful in planning a WLAN solution prior to performing a site survey?

A. Ekahau Survey

B. Air Magnet Wi-Fi Analyzer

C. Air Magnet Survey

D. Cisco WCS

E. Cisco Spectrum Expert

Discussion 0

Correct Answer: D Vote an answer

Question #5

Refer to the exhibit.

A company will start conducting an inventory of the outdoor yard area with 2.4 GHz bar code scanners. Which two Cisco recommended antennas should be used for the survey and mast mounting? (Choose two.)

A. AIR-ANT1728

B. AIR-ANT5959

C. AIR-ANT1949

D. AIR-ANT2410Y-R

E. AIR-ANT2506

F. AIR-ANT24120

Discussion 0

Correct Answer: E,F Vote an answer

Question #6

What are the best practice minimum and recommended signal level values for a Location Services Survey?

A. minimum: -75dBm; recommended: -72dBm

B. minimum: -65dBm; recommended: 60 dBm

C. minimum: -70dBm; recommended: -68 dBm

D. minimum: -80dBm; recommended: -78dBm

Discussion 0

Correct Answer: A Vote an answer

Question #7

Which three post-installation checks should an engineer perform after a new wireless installation? (Choose three.)

A. Verify that the cell overlap is 20%.

B. Check for adequate signal levels as surveyed.

C. Conduct a passive survey of 802.11a and 802.11b.

D. Verify that the minimum data rate is 24 Mbps.

E. Check for co-channel interference.

F. Conduct a passive and active survey of each media type in use.

Discussion 0

Correct Answer: B,E,F Vote an answer

Question #8

Which three types of WLAN data, location, and voice testing should be included in the installation customer report? (Choose three.)

A. Results from a WCS WLAN client audit

B. Results from an ISP throughput test

C. Results of the WCS planning tool

D. Results from Cisco Unified Communications Manager cluster failover tests

E. Results of the coverage audit performed with the site survey mapping tool per media installed on 802.11a/b/g/n networks

F. Results of a location readiness test

Discussion 0

Correct Answer: B,E,F Vote an answer

Question #9

A wireless engineer is gathering equipment to perform a point-to-point bridge survey. What three pieces of equipment should be used? (Choose three.)

A. 1310 with internal antenna

B. 1552e with three AIR-ANT2547-N=

C. 3502e with AIR-ANT2460NP-R

D. 1552e with AIR-ANT2588P3M-N=

E. 3502i with dual band directional antennas

F. 1142 Series with internal antennas

G. 1132 with a 10dBi Yagi

Discussion 0

Correct Answer: A,C,D Vote an answer

Question #10

DRAG DROP

Discussion 0

Correct Answer:

Question #11

Which type of information should be included in an installation report?

A. Soft copies of configuration for switches, routers, controllers, and location appliances.

B. The exact number of users the WLAN will support.

C. A detailed description of the WLAN environment during the post-installation testing, for example, number of people present, furniture, no furniture, and sources of interference present.

D. A complete characterization of the external WLAN environment.

Discussion 0

Correct Answer: A Vote an answer

Free 642-732 Questions for Cisco Conducting Cisco Unified Wireless Site Survey (CUWSS) v2.0 642-732 Exam as PDF & Practice Test Engine

Download Free Cisco 642-732 Demo